Lift the chin alone and it looks off
If the chin stands out while the jawline stays flat, a step forms between them. The flow from below the ear to the chin must be read together.

Chin Balance · Lower Face
Within the lower-face geometry of nose, lips, chin and jawline, we first separate what the cause actually is
The chin is where misreading the cause produces the widest gap in results.

If the chin stands out while the jawline stays flat, a step forms between them. The flow from below the ear to the chin must be read together.
"Looks wide" can be muscle; "looks heavy" can be fat. Adding volume to either makes it worse.
Chin projection is a value read in profile. Deciding on the frontal impression alone throws the profile off.
When the length or width of the lower face is itself out of proportion, there are changes that added volume cannot make.
Muscle, volume, fat and skeleton are different causes, and filler addresses only one of them. We start by separating which one weighs most.
The position of the chin is decided only after reading all five.

We look at where the lips sit on the line joining nose tip and chin. This is where "the chin is short" and "the nose is high" separate.
If the lower third is short within the upper-middle-lower proportion, the whole face reads flat. Length and projection are separate problems.
We check directly how much the muscle thickens when you clench. If it is muscle, the approach is not volume.
The whole line, not only the chin, has to read as one. If the middle is hollow, lifting the chin will not tidy it.
If the angle from under the chin to the neck has collapsed, the jawline is buried. In that case something has to be read before volume.
We approach a range of concerns about the proportions of the lower face with filler.
Seen from the side, the chin sits back behind the line of the lips. Filler creates projection and improves the profile proportion.
The tip of the chin points down or tilts backwards. The angle and the volume are designed together.
The lower third of the face is relatively short, making the whole face look flat. Length is added to bring the proportions into line.
The two sides of the chin differ in shape. Volume is added to the smaller side to balance it.

We design the position and degree of projection of the chin tip, considering the front and side proportions together. Excessive projection ends up looking unnatural.
A chin tip that stands out on its own looks unnatural. We design the whole flow of the facial line, from below the ear to the chin tip.
We consider the angle at which the jawline flows naturally into the neckline. Where there is a double chin, a combined treatment is recommended.
Filler recovers quickly and can be corrected, but it has a limited duration. In consultation we advise honestly on whether filler or an implant suits you better.

Making that distinction is the first task of the consultation.
| Item | Chin filler | Chin implant |
|---|---|---|
| Method | Injection | Open surgery |
| Anaesthesia | Topical anaesthetic cream | General or sedation |
| Recovery | 1–3 days | 2–4 weeks |
| Duration | 8–18 months | Long-lasting (varies) |
| Reversible | Yes (dissolvable) | Revision surgery needed |
| Best suited to | Light correction, trying it first | A markedly weak chin, when long-term is wanted |
When the length or width of the lower face is itself out of proportion, it exceeds what added volume can achieve. In that case we do not recommend filler — we say so first.
Two receding chins are not the same: short in length and set back are designed differently.
It depends on the degree of correction and your purpose. If you are experiencing a change for the first time, or want light refinement, filler suits you. If you want a marked and longer-lasting change, an implant may be better. We compare them honestly in consultation.
30–40 minutes including consultation, with the treatment itself around 15–20 minutes. You can go about your day afterwards.
The chin moves little, so it lasts comparatively long at 8–18 months. It can differ with the product used and your own metabolism.
Yes — combining a chin filler with double-chin botox or fat-dissolving injections is complementary. An integrated design can produce a more natural result.
It mostly settles within 1–3 days. There is less bruising when a cannula is used, and waiting about a week for it to settle lets you see the final shape.
It is performed after applying a topical anaesthetic cream, and the filler itself contains an anaesthetic. There can be a little pressure, but pain is kept to a minimum.

Petit procedures do not include a separate aftercare program; if swelling care is needed after the procedure, it is offered at 50% of the cost.
Legal Notice
※ If care cannot be provided due to reasons such as equipment malfunction, the affected care item may not be offered; as a service item, it is non-refundable.
※ Depending on your constitution and response, reactions such as swelling, bruising, and inflammation may occur after the procedure.
Performed by a board-certified plastic surgeon · Muscle, volume, fat and skeleton separated · Only as much as needed Sinsa, Gangnam, Seoul — NB Plastic Surgery
